HBM GEN3i, Руководство пользователя

Страница: 99 / 1160

3 Loosen the small set screw on both ejectors on the card.
Loosen
Screws
Figure 7.3: Removing card (Part 1)
4 Press the inner grey button on each ejector to release the catch.
Press Inner
Grey Button
on Ejectors
Figure 7.4: Removing card (Part 2)
5 Press both ejectors outward to release the card. They act as levers to gently
pull the card from its backplane sockets.
6 Slide the card out of the GEN3i unit.
7.2.2 Installing cards
To install a card:
1 Power off the GEN3i system and remove the power input cable.
2 Ensure that the ejector levers are in the farthest outermost position, tilting
away from the card.
3 Slide the card into its guide rails until the ejectors contact the perforated
metal strips on the left and right.
4 Press both ejectors inward to seat the card. They act as levers to gently
pull the card into its backplane sockets. The grey button should snap to its
default position and lock the ejectors.
5 Tighten the small set screw on both ejectors on the card:
GEN3i
I3763-3.1 en HBM: public 99