HBM DMP41, Описание интерфейса

Страница: 24 / 92

Command set of the HBM interpreter
Important agreements
24
A03474_04_E00_00 HBM: public
DMP41
S
The command end character is indicated by (x).
Permitted command end characters are:
';', LF, LFCR, CRLF
For output commands:
S
The command end character is indicated by (y).
The command end character is always CRLF.
Interfaces - serial
S
Computer communication in the RS‐232‐C interface starts with the
permitted control character.
'CTRL R' or 'CTRL B' and ends with 'CTRL A'
Acknowledgment behavior
S
You can select whether the response of the DMP41 should be output or
not following setting commands.
Output commands - indicated by a ? - always generate output data (see
SRB command).
Outputs for setting commands are:
- '0' for error‐free process or
- '?' if an error occurs.
This also applies to unknown commands.
E.g ASS2(x)
0(y)
Standards
S
The standard IEEE 488.2, which defines the codes, formats and various
general commands, is taken into account as far as possible.
5.1.1 Command structure
All commands used are created according to a specific structure.
There are basically two command types:
S
Setting commands:
The DMP41 is set via the computer.