DIS2116
28
HBM
A2540-1.1 en/de
F1 moves the cursor to the required line
F2 moves the cursor left, F3 right
F4 deletes the line character by character from the right
The unit cannot be deleted, it corresponds to the unit set in the parameter
menu ”SCALE PARAMETERS−PARAMETER”.
8.2.2
x Delete vehicle
The F1
↵
key switches the function line mode between “Find vehicle” and
“Edit vehicle”.
+
3
/
x
0
F1
F2
F3
F4
Display illustration:
Edit vehicle data function line
Press the F3 (x ) key to delete the selected vehicle (marked by a black bar)
from the database.
8.2.3
0
Create vehicle
The F1
↵
key switches the function line mode between “Find vehicle” and
“Edit vehicle”.
+
3
/
x
0
F1
F2
F3
F4
Display illustration:
“Edit vehicle data” function line
Press the F4 (
0
) key to open an empty editor window. The entries can be
made here as described in Point 13.2.1 ”Edit vehicle data”.
The entered data is stored with the
key. An empty window cannot be saved.
Use the
key to close the window without saving the data.
8.3
Vehicle weighing mode Check-in/Check-out
In the vehicle weighing mode Check-in/Check-out, the weight determination
for the load is based on 2 measurements. The weight of the arriving truck is
recorded with Weighing1 and the weight of the departing truck with Weig-
hing2. The difference is the weight of the loaded or unloaded material.
It is also possible to use the emtpy weight (pretare) stored with the truck data
as the weight for the arriving truck. The arriving truck then does not need to
drive onto the scale.
