HazeBase THE FAB, Инструкция по эксплуатации

Страница: 7 / 28

THE FAB
4. Preparation
4.1 Selection of the location
The location where THE FAB is operated must be
• have good ventilation, with cold and fog-free air
• Be dry
• Be vibration and shock free
• consist of a non-flammable footprint
• be far enough away from easily flammable objects
• have an ambient temperature between 5°C and 45°C
• have a relative humidity of less than 80%.
4.2 Changing the canister
• Release the plug-in nozzle from the quick coupling by pressing the locking
button
• Hold the suction hose in the right edge of the fluid compartment
• Remove the canister from the fluid compartment
• Unscrew the tank cap from the empty canister and screw it onto a new, or
full, canister.
• Slide the canister back into the fluid compartment.
• Put the plug-in nozzle back into the tank cap.
• Reset the fluid display (see chapter 7.4)
• If the pump has run dry, hold THE FAB with the front side down and let it
mist for a few seconds. The fluid pump will then fill completely with fluid
again.
5. haze fluid
Please use only the original base*V fluid for THE FAB.
6