HAWEKA RPV1300, Руководство по эксплуатации

Страница: 27 / 36

R
UNOUT
M
EASUREMENT
D
EVICE
RPV1300
RPV1300 Operating Instructions
27
8 Control measurement after matching
8.1 Control measurement
When the runout on the wheel has been corrected by
the matching procedure the program can be used to
carry out a corrective measurement for this wheel.
For this, the measuring device has to be aligned on the
corrected wheel.
•
Select the “ Control measurement ” button
(
Fig. 59
)
The laser sensor for tyre measurement has to be re-
assigned to the program.
•
Select the required laser sensor on the diagram on
the monitor.
(Fig. 60)
The “ X ” on the tyre in the diagram indicates
the first measured tread lug from the initial
measurement.
•
The wheel has to be turned into position far
enough so the measurement can be started on
this first tread lug again.
(Fig. 60)
•
Click on “ Next ” and start by rotating the wheel
evenly.
The screen shows the number of measured tread lugs
and displays the measured values graphically.
(Fig. 61)
•
When the wheel has been moved by one full
rotation until the first tread lug was recorded a
second time, a signal can be heard and the
measurement is completed.
(Fig. 59)
(Fig. 60)
(Fig. 61)