HAWEKA RPV1300, Руководство по эксплуатации

Страница: 20 / 36

R
UNOUT
M
EASUREMENT
D
EVICE
RPV1300
RPV1300 Operating Instructions
20
7 Measurement recording
7.1 Entering vehicle, wheel and rim data in the program
At least two laser sensors are connected to the PC and the PC is switched on. The program
rpv1300 is running and is set to the start page.
•
Click on “ Start measurement ”.
•
Enter vehicle data.
(Fig. 33)
Entering the correct wheel geometry with
number of tread lugs and wheel diameter is
absolutely required for evaluation.
•
Click “ Next ” to finish vehicle entry and continue to
the next program page.
(Fig. 34)
•
Select front or rear axle on the model on the right.
•
Enter tyre and rim information in the corresponding
fields.
Information about centring:
How well is the wheel mounted on the hub?
(Fig. 35)
GOOD: The distance between inside rim
opening and wheel hub is the same for
the entire circumference.
BAD: The wheel is not fixed centrally on the
wheel hub, the gap is not the same all
around.
NOT TESTED: No information about concentric fit
between wheel and hub.
GAP VALUE: You can enter a value (mm) for the gap measurement here. This information will
later appear as a note on the log.
The gap value has NO influence on the result of the evaluated measuring points!
SUSPENSION: This note field can be used for entering details about the actual situation of the
axle suspension on the vehicle. This information will be displayed on the log.
(Fig. 33)
(Fig. 34)
(Fig. 35)