HAWEKA RPV1300, Руководство по эксплуатации

Страница: 16 / 36

R
UNOUT
M
EASUREMENT
D
EVICE
RPV1300
RPV1300 Operating Instructions
16
5.1.4 Laser symbol information:
During the entire program execution the connection to
the laser sensors and the measurement procedures is
verified and displayed at the top right.
(Fig. 14)
Description of symbols:
Display is grey. The laser sensor is not connected to the
system. Unknown state.
(Fig. 15)
The display flashes yellow and red alternately. The program is
attempting to establish a connection with the lasers.
(Fig. 16)
Display is green. Connection to laser established.
(Fig. 17)
Display is green with a red centre: The connection is
established but no measuring points were found, or flashing
during setup of laser sensor (
Fig. 18
)
Display is green with a yellow centre: Connection is established
and wheel was detected.
Ready to for measurement recording
(
Fig. 19
)
Display is striped grey/yellow. Laser was removed from the
interface.
(Fig. 20)
Display is red. Error in of measurement recording.
(Fig. 21)
5.1.5 Instructions
Specifying the default for displaying/hiding operating
instructions during measurements.
(Fig. 22)
The instructions window can be
displayed/hidden at any point in the
program. Click on the
Instructions button
on the program page.
(Fig. 15)
(Fig. 16)
(Fig. 17)
(Fig. 18)
(Fig. 19)
(Fig. 21)
(Fig. 22)
(Fig. 20)
(Fig. 14)