AXIS4000
W
HEEL
A
LIGNMENT
S
YSTEM
HAWEKA Wheel Alignment –AXIS4000
52
14 Vehicles with two steerable front axles
To examine the parallelism of the two steerable front
axles, the first and second steering axle must be
measured fully beforehand and if necessary adjusted.
The parallelism of the steering axles can on-
ly be examined once the steering gear mid-
dle position on the first axle has been
correctly adjusted.
(Fig. 113)
•
To prepare for the measurement, the camera
measurement heads are secured to the first axle
on the left vehicle side and to the second axle on
the right vehicle side.
•
Both cameras are aligned against the rear reflec-
tors.
•
The wheels on the first steering axle stand in "For-
ward direction"; this requires the steering gear to
be brought into a central position.
•
Then select the "
Parallelism of steering axles
"
button.
(Fig. 114)
The program immediately detects the angle of the ax-
les in relation to each other and the measured value is
displayed.
(Fig. 115)
•
Press the "
Continue"
button to return to the axle
overview.
•
If there is no parallelism (
0° 00’
), an adjust button
will appear; this is selected to correct the vehicle
axles in relation to each other.
•
The axles can be adjusted to the necessary value
using the displays.
(Fig. 116)
•
Then press the "
Continue"
button to return to the
second axle overview.
(Fig. 116)
(Fig.115)
(Fig. 114)
(Fig. 113)
