6
Start-up
Observe the following safety instructions additionally to the safety instructions in chapter
.
CAUTION
Risk of re due to short circuit currents.
Touching live components, directly or indirectly, will cause injuries or death.
Electrical and electronic components must only be replaced and connected by trained specialist
personnel.
Comply with the relevant electrical safety regulations.
DAMAGE
Damage to equipment due to the EMC interference
Electromagnetic waves lead to malfunctions of electrical or electronic equipment.
To prevent this:
Twist and shield the conductors.
Route intersections at right angles.
Connect the shield at only one end and close to the control system at ground potential.
Route control cables and power cables separately.
Leave a 10 to 20 cm gap between the control cables and power cables.
Provide separate shields for analogue and digital control lines.
Only trained specialist personnel may perform commissioning.
The unit is secured against being switched on unintentionally.
1. Check the battery pack has been connected correctly:
✓
Mechanical: Attachment to the higher-level machine, the frame and the base
✓
Electrical: Wiring, power supply, control
✓
Penetration of liquids into the device (for instance during installation work) must be prevent-
ed. (Penetration of liquids will lead to leakage currents or even outright short circuits, leading to
damage or destruction (by re) of the device.)
✓
Cables must be sealed.
2. Set up the CAN interface. (
). Check
3.
"Safety devices and performance limitations", page 21
.
20/39
B 6130 - 02-2022 - 1.0en
HAWE Hydraulik SE
