8.3.5.2 Base-side rod end
Aids, tools, materials
■
Replacement rod end according to the technical data specifications
■
When replacing on a HLU LE-X (M):
- Open-end wrench, sizes 22 and 24 mm
- Torque wrench with fork size 24 mm
- Tap M 16
- Torques according to technical drawing
■
Degreaser, threadlocking adhesive, brass brush and lint-free cloth according to the recommended
cleaning and care products on page (
■
Gap checker according to technical data
DAMAGE
Damage due to heat-up of the foot-side pivot mounts
Heating-up of the foot-side pivot mounts will damage seals and cause leaks in the hydraulic system.
►
Never heat the base-side rod ends.
►
Use the listed open-end wrenches to unscrew the rod ends.
1. Shut down hydraulic locking unit and secure it against inadvertent restarting.
2. Remove the hydraulic locking unit from the ride.
3. Clamp the hydraulic locking unit in a vise so that the rod end is easily accessible.
Use jaw caps.
Be careful not to damage the connection block.
4. Open the rod end using a size 24 open-end wrench.
44/63
B 6052-21 -
11
-2021 - 1.7
HAWE Hydraulik SE
