SKU 94795
For technical questions please call 1-800-444-3353. Page 3
10.
Always check hardware and assembled parts after assembling. All connections should be
tight and hardware tightened.
11.
Make certain to follow all local laws regarding vehicles and tail lights.
12.
Do not cut or rewire any part of the Tail Light or vehicle.
13
Make certain the vehicle is turned off before performing any installation, service or
maintenance.
14.
Harbor Freight Tools is not responsible for damage to the Light or to the vehicle which is
a result of improper installation.
Warning:
The warnings, cautions, and instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into
this product, but must be supplied by the operator.
Unpacking
When unpacking your Flange Mount 4” LED Tail Light, check to make sure that the product is intact
and undamaged. If any parts are missing or broken, please call
HARBOR FREIGHT TOOLS
at:
1-800-444-3353.
Installation
Your 4” Flange Mount Tail Light will require complete installation. It is important that you read the
entire manual to become familiar with the product BEFORE you install and use the 4” Tail Light.
If you do not have experience doing this type of electrical work, the job should be done by an
automotive service technician.
1.
Make certain that the vehicle is OFF and the battery disconnected before installation or
performing service or maintenance. Proceed with the following steps for installing the Tail
Light.
2.
Install the Tail Light into a 4-1/2” round hole facing the rear of the vehicle. If your vehicle
does not have a hole of this size then drilling a hole will be necessary. Make certain that the
hole and connected wiring remain water resistant.
Warning:
When drilling holes, beware of any hidden electrical lines or cables. Make sure
you don’t damage or weaken the structural integrity of the vehicle.
3.
Use a rubber gasket (not included) to line the hole and provide protection for the Tail Light.
Connect the Terminal Pins to your vehicle’s electric wiring system. Always review the
manufacturer’s manual for the vehicle to avoid any damage to the vehicle.
Harbor Freight Tools is not responsible for damage to the Light or to the vehicle which is a
result of improper installation.