Page 5
For technical questions, please call 1-888-866-5797.
Item 58114
2-Wheel Dirt Bike Loading and Unloading
• These Ramps are for use with 2-wheeled vehicles only.
Do not use these Ramps to load/unload 3-wheeled vehicles.
• Use with 2-wheeled vehicles only. Do not use with ATVs or other 4-wheeled vehicles.
• Do not use these Ramps to load or unload any vehicle that weighs more than 800 lb.
• Do not use these Ramps to load or unload any vehicle with wheel width wider than the Ramp.
• Do not use these Ramps to load or unload any vehicle that is carrying gear on its racks.
• Do not use these Ramps if the tailgate on the vehicle being loaded or unloaded
is higher than half each Ramp’s length (40″).
WARNING! TO PREVENT SERIOUS INJURY: Riding an ATV while loading
or unloading is dangerous and should not be attempted.
WARNING! Be aware of dynamic loading!
Sudden load movement may briefly create excess
load causing the Ramp to fail.
WARNING! TO PREVENT SERIOUS INJURY:
All persons not involved in the process
must stand clear of the Ramp and truck. Make sure no pets are nearby.
Loading
1. Do not attempt to load any dirt bike or other 2-wheel
motor bike alone. Have a qualified adult assist.
2. Line up the 2-wheel dirt bike with the Ramp.
3. With one person pushing the dirt bike slowly
up the Ramp, a helper should be in the bed of
the hauling vehicle both to guide and to apply
the brake if it is necessary to stop the dirt bike
while it is on the Ramp. Have one person with
a hand on the dirt bike hand brake for safety.
4. Once the person inside the truck bed has hold
of the handle bars, apply the brake and steady
the dirt bike while the other person moves
behind the dirt bike (but off to one side) and
pushes it all the way into the truck bed.
NOTE:
While most dirt bikes are light enough
to safely load with two people, a third person
can make the job easier and safer.
5. Once the dirt bike is safely loaded, secure it
with four cam buckle tie-downs (not included),
one on each side of the front, and one on
each side at the rear of the dirt bike.
Unloading
1. Position the Ramp against the truck tailgate
behind the rear tire of the dirt bike and
attach the Safety Strap to the truck bed.
2. Remove the cam buckle tie-downs
securing the Bike (not included).
3. Slowly and carefully while using an assistant,
push the dirt bike backwards until the back
tire is at the top of the Ramp. With one person
on the ground behind and to the side of the
Ramp, slowly push the dirt bike onto the Ramp.
Someone must always hold the hand brake.
4. Slowly work the dirt bike down the
Ramp and onto the ground.