MAINTENANCE
12
Form No. TFC461RM-0108
GENERAL
Hatco Thermo-Finisher conveyor food finishers are
designed for maximum durability and performance
with minimum maintenance.
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
NOTE: When the unit is HOT the blower fans will
remain on even when the POWER switch is
turned off.
CLEANING - EXTERIOR
To preserve the bright finish of the unit, it is
recommended that the exterior surfaces be wiped
daily with a damp cloth. Stubborn stains may be
removed with a good stainless steel cleaner or a
non-abrasive cleaner.
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your
Thermo-Finisher, marring its appearance and
making it susceptible to dirt accumulation.
CLEANING - INTERIOR
It is recommended that the interior and conveyor
belt system be wiped daily using a damp cloth.
Stubborn stains can be removed using a small brush
and mild soap.
Glass Surfaces
To avoid any injury, move the POWER switch to
OFF, unplug the unit from the power source, and
allow
to
cool
before
performing
any
maintenance.
Upper and lower glass surfaces can be cleaned
after the unit has
cooled for at least one hour
.
1. Remove the heat retention doors from the unit.
2. Lift the idler shaft from the brackets and allow
shaft to drop down.
3. Lift the conveyor belt up.
4. Carefully scrape loose and wipe off any food
debris that has accumulated on the glass.
Do not remove the glass from the unit for
cleaning purposes. Doing so may cause injury
or damage to the unit.
WARNING
WARNING
CAUTION
CAUTION
5. Remove any stains from the heating surfaces by
wiping off the glass using a moist cloth and
ceramic cooktop cleaner.
6. Reposition the idler shaft into the brackets and
reinstall the heat retention doors.
NOTE: The conveyor belt does not require any
lubrication.
Unit is not waterproof. DO NOT submerge in
water. Do not operate if it has been submerged
in water. Do not steam clean the interior or flood
with water or liquid solution.
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
This product has no “user-serviceable” parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Replacement Parts when service
is required.
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement
parts
do
not
have
the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Genuine
Hatco
Replacement
Parts
when
repairing Hatco equipment. Failure to use
Genuine Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or
burn.
WARNING
WARNING
WARNING
WARNING
WARNING
Содержание THERMO-FINISHER TFC-461R
Страница 19: ...NOTES Form No TFC461RM 0108 17...
