21
Quality agreement
WARRANTY CLAIM — YES OR NO?
Rust:
To provide a proper basic protection of the chassis, it has undergone
a rust-proofing treatment. However, rust-stains may be found when lacking
maintenance. This case will not be covered by the warranty.
Scratches:
Scratches caused by wear and tear will not be covered by the warranty.
Mould formation:
Fabric parts, having become wet, should be dried pro-
perly to prevent mould formation (see Instructions). Mould formation will not
be covered by the warranty.
Bleaching of the fabrics:
We confirm that the
fabrics comply with the established standards. It cannot be ruled out that
colours of the fabrics may fade while the parts are exposed to direct sunlight,
washed too frequently, come into contact with sweat and detergents, or
suffer abrasive wear (especially on those parts where the pram is handled).
Consequently, colour fading is excluded from the warranty. It is unavoidable
that colours sometimes differ slightly from one individual batch to the next,
which is why this case will not be covered under the warranty.
Knob forma-
tion on fabrics:
We recommend that you apply general clothes care. As with
woollen sweaters, the knobs can easily be removed by using a clothes-brush
or burling machine.
Tearing of seams, fabrics, press studs :
At the time
of purchase, please check carefully that all the fabric parts, seams and snap
fasteners have properly been sewn and fastened. In case of a possible com-
plaint concerning seams/defective snap fasteners, a claim must immediately
be reported to your dealer after the defect has been discovered.
Wheels:
As
wheels used on prams will not be balanced, they may show slight run-outs
(„wobbles“). Worn tires will be regarded as natural wear and tear. No claim
can be raised if your pram, using pneumatic tired wheels, has a „flat“. This
will be attributed to extraneous causes — a small hole caused by a pointed
object, or pushing the pram about when it has not got enough air in the tire.
This case will not be covered by the warranty.