HARTCOM-W2 User Manual
4/2/2018
Designed and Produced under
Page 23 of 71
ISO 9001:2008 Certification
The following table describes the details about the device configuration:
Step
Action
1
Follow the steps in section “6.2 Viewing device configuration” to view the device parameter(s) you
want to change, e.g.
2
There are three types of variables: dynamic, read/write and read only. The parameters that are
grayed out indicate that these are dynamic variables (variables that get updated online by the
device) or read only variables.
The status of device parameters are represented as follows:
Bold Font = Modifiable Values
Normal Font = Menu Item
Gray Font = Dynamic or Read Only Variables
3
From here you can select the parameter and configure the values, as required. However, there are
several types of parameter and the topics in the following sections explain how to configure the
different device parameter types.
4.3.2 Variable
To edit the parameter variables of the connected device, perform the following steps:
Step
Action
1
Follow the steps
in section “6.2 Viewing device configuration” to view the device parameter(s) you
want to change, e.g.
