HARRISTON INDUSTRIES 93066, Руководство оператора

Страница: 48 / 92

43
4.8 ATTACHING TRACTOR
When attaching the planter to a tractor, follow
this procedure:
1. Clear the area of bystanders, especially small
children.
2. Make sure there is enough room and
clearance from obstacles to safely back up to the
planter.
3. Back up slowly and align the link arms as
required for your machine.
4. Two point attachment with Quick Hitch.
a. Align the claws on the Quick Hitch
slightly below the mounting pins on the
planter.
b. Back up until the pins on the planter are
above the claws.
c. Raise the 3-point hitch until the pins
“seat” in the claws.
d. Be sure the retainers are released to hold
the pins in the claws.
e. Adjust the turnbuckle on the top link to
position the Quick Hitch frame vertically
when the lower lift arms are horizontal.
f. Set the 3-point hitch in the non-sway
position.
g. Set the lower links on the tractor in the
free float position.
IF YOUR TRACTOR IS NOT EQUIPPED
WITH A QUICK HITCH, IT WILL BE
NECESSARY TO INSTALL THE
MOUNTING PINS THROUGH EACH BALL
ON THE 3-POINT HITCH. BE SURE TO
INSTALL THE RETAINER ON EACH PIN.
5. Connect the hydraulic circuits.
6. Route the electrical control console into the
cab. Route the electrical cord over the hitch and
secure in position with clips, tape, or plastic ties.
Be sure the wire doesn't dangle and contact the
ground or become pinched. Allow enough slack
for turning.
7. Mount the Harriston console in tractor. Be
sure the console location does not interfere with
other controls.
CONNECT THE POWER CABLE
DIRECTLY TO THE TRACTOR
BATTERY
. DO NOT CONNECT TO
TRACTOR CONVENIENCE OUTLETS.
HARRISTON WILL NOT BE
RESPONSIBLE FOR ANY CONSOLE
MALFUNCTIONS IF CONNECTED TO
A CONVENIENCE OUTLET.
8. Connect the console cable (tractor) to the
product (planter) cable.
9. Program or check the program numbers in
the console.
10. Start the tractor and raise the machine.
11. Remove the pins from frame stands. Raise
the stands into storage position and reinstall the
pins.
12. Raise and lower machine a couple of times
to be sure hydraulic hoses and wires are secured
properly and are not binding or pinching.
13. Check rear lift wheels for function and
operation.