Harris Intraplex HD Link RF, Руководство по установке и эксплуатации, Страница: 95 / 181

4 – Front Panel Configuration & Operation HD Link Installation & Operation Manual
Version 2, April 2010
Harris Corporation 4-61
Intraplex Products
Figure 4-111. Service Setup

Service Sync
2. Press Enter on the Service Sync screen. The Service Sync configuration screen appears (Figure
4-112).
Figure 4-112. Service Sync

Service Sync Configuration
3. Press these buttons on the display to set the receiver sync:
• Press

to set the receiver sync ON to get information from the transmitter and
automatically change certain receiver parameters or OFF to make all receiver changes
manually.
• Press Enter to keep changes until you can Apply them on the previous screen.
• Press Cancel to erase your changes and return to the previous value.
Notes: If you make any changes to this screen, you must select Apply and press Enter on the
previous screen to save and apply changes.
You need to set the
Service Sync OFF before making any changes to the Service Profile
parameters.
4.2.6 Configure the Systems for Redundancy
Before configuring your HD Link systems for redundancy, check that you have correctly set up and
wired both transmitters and receivers (Section 3.4). To set up your HD Link system for redundancy,
you need to set redundancy parameters on each unit (the main transmitter and redundant transmitter
and/or the main and redundant receiver).
4.2.6.1 Configure Redundant Transmitters
Both transmitters should have the same HD port IP address when the external Ethernet equipment is
configured to use the HD Link system as a default gateway, and both should have a Standalone
redundancy role. To configure your transmitters for redundancy or check configuration, perform these
steps:
1. On the System Setup menu of one transmitter’s front panel display, select Network Setup and
press Enter. The Network Setup menu appears (Figure 4-113).