Harris Intraplex HD Link RF, Руководство по установке и эксплуатации, Страница: 94 / 181

HD Link Installation & Operation Manual 4 – Front Panel Configuration & Operation
Version 2, April 2010
4-60 Harris Corporation
Intraplex Products
Figure 4-109. RF Profile – Transmitter and Receiver
3. Configure each RF Profile parameter in this way:
a. Press

as needed to select the parameter.
b. Press Enter.
c. Press

to navigate to the field to be changed.
d. Press

to make changes.
e. Press Enter to save any changes.
f. Press Cancel to return to the RF Profile menu without saving changes.
g. To return to the Service Setup menu, select Apply and press Enter.
4.2.4 Configure the Service Profile Parameters
To configure the audio port and user IP rate parameters, perform these steps:
1. On the Service Setup menu, select Service Profile and press Enter. The Service Profile screen
appears (Figure 4-110).
Figure 4-110. Service Setup

Service Profile
2. Configure each Service Profile parameter in this way:
a. Press

as needed to select the parameter.
b. Press Enter.
c. Press

to navigate to the field to be changed.
d. Press

to change the parameter.
e. Press Enter to save any changes.
f. To return to the Service Setup menu, select Apply and press Enter.
g. Press Cancel to return to the Service Profile menu without saving changes.
4.2.5 Configure the Receiver’s Service Sync
When you configure the receiver’s Service Sync, you only need to change specific parameters on the
transmitter, and the changes are automatically made on the receiver. To configure the receiver to get
information from the transmitter at a rate of once per second, perform these steps:
1. On the Service Setup screen, select Service Sync and press Enter. The Service Sync screen
appears (Figure 4-111).