Harris Intraplex HD Link RF, Руководство по установке и эксплуатации, Страница: 77 / 181

4 – Front Panel Configuration & Operation HD Link Installation & Operation Manual
Version 2, April 2010
Harris Corporation 4-43
Intraplex Products
With the sync on, you only need to change these parameters on the transmitter, and the changes are
automatically made on the receiver.
Notes: When you use return path (Section 4.1.5.1 – Network Setup Menu ) with redundant transmit
systems, you must turn Service Sync ON , allowing the receiver to connect to the active
transmit side system.
You need to turn the
Service Sync OFF before making any changes to the Service Profile
parameters (Section 4.1.6.3). Section 4.2.5 gives steps for configuring the service sync.
Press Enter on the Service Sync screen to access the Service Sync configuration screen (Figure 4-
68) and set the receiver’s sync with the transmitter to ON or OFF.
Figure 4-68. Service Sync

Service Sync Configuration
Press these buttons on the display to change the sync status:
• Press

to set the receiver sync ON or OFF.
• Press Enter to keep changes until you can Apply them on the previous screen.
• Press Cancel to erase your changes and return to the previous value.
Color Codes: White = currently applied value; yellow = value changed but not saved or applied.
Cancel: Press this button to return to the previous screen.
Note: If you make any changes to this screen, you must select Apply and press Enter on the
previous screen to save and apply changes.
4.1.7 Test Screens
Select Test on the Main front panel screen to access the Test menu screen (Figure 4-69).