Harris Intraplex HD Link RF, Руководство по установке и эксплуатации, Страница: 36 / 181

HD Link Installation & Operation Manual 4 – Front Panel Configuration & Operation
Version 2, April 2010
4-2 Harris Corporation
Intraplex Products
● Toggle between operating and standby.
● Navigate between screens and within screens.
● Add or change any configurations.
Figure 4-1. HD Link Front Panel – Receiver
Press the Operate / Standby single-purpose button to toggle between the two modes. Press the other
six multi-purpose buttons to drill up/down levels, navigate within a screen, or apply the parameters
you set.
● To navigate between screens – After selecting a menu or a command on a menu, press an arrow
button and then press Enter to
•
Navigate to the next or previous menu/command.
• Drill up/down a level.
● To navigate within a screen – After selecting an item on a screen, press an arrow button and then
press Enter to
•
Navigate to the next or previous item on a screen.
• Drill down to more detail on an item.
• Open the item for editing.
Press the Cancel button to exit a screen without applying any entered changes or to drill up a level.
There are some screens which do not allow you to select all fields (or any fields), because the fields
which cannot be selected are not configurable or there is no additional information for these fields.
Table 4-1 gives the front panel buttons and their functions.
Table 4-1. Front Panel Buttons
Button Command Function Screen Item Function
Up Move to the command above. Move to the item above.
Down Move to the command below. Move to the item below.
Left Move to the command to the left. Move to the item to the left.
Right Move to the command to the right. Move to the item to the right.
Enter Drill down a level. Get more detail or open an item to edit it.
Cancel Drill up a level. Return to the previous screen without saving changes.
4.1.2 Initial Screen
When you turn on the HD Link system, this initial screen appears (Figure 4-2):