Harris HFS6801+, Инструкция по установке и эксплуатации

Страница: 41 / 72

HFS6801
+
Installation and Operation Manual27
Chapter 3: Operation
5. Rotate the hex switch to another parameter number/letter in the
current bank, and then repeat step 4.
or
Rotate the hex switch to “0” again to select a different bank, and
then repeat steps 3 and 4.
Recalling Default Parameter Settings
Table 3-3 on page 29 describes all of the parameter settings for the
HFS6801
+
modules, including the original factory defaults. To return
this module to its default settings, you can either reset each parameter
individually or do a global recall following this procedure:
1. Rotate the hex switch to “0.”
2. Toggle the navigation switch to the bank number “0.”
Use the control LEDs to verify which bank you have selected, or
use an available 6800
+
software control option (serial/local or
Ethernet/remote) to aid in confirming your bank selection.
3. Rotate the hex switch to the global recall parameter “F . ”
4. Toggle the navigation switch to “On.”
Use an available 6800
+
software control option to aid in viewing,
setting, and confirming the parameter value.
Reading Software and Hardware Versions
The current software version of your HFS6801
+
modules can only be
viewed using a CCS-enabled control panel or a CCS software
application, such as Pilot or
+
Pilot Lite. See your RCP-CCS-1U
Installation and Operation Manual, CCS software application user
manual , or CCS software application online help for information on
viewing software and hardware version numbers.