Harris FR6822+, Инструкция по установке и эксплуатации

Страница: 86 / 128

Chapter 4
FR6822
+
QXFE Configuration, Monitoring, and Control
72
Copyright © 2008-2011, Harris Corporation
Syntax
getMACAddr
Response
The getMACAddr command returns the MAC address of the target module in the
following format:
MAC Address: 02:90:F9:00:01:2A
setipaddr
Definition
This command sets the target IP address to the one stated in the function argument. The
input arguments could be null, in which case the function is interactive (prompting the user
to enter each parameter individually). Otherwise, from the command line in the format, you
should enter a command similar to the following example:
setipaddr
ip=10.1.1.101
gw=10.1.1.100
subnet=255.255.255.0
You may also want to add the command
reboot
to the end of the
command line to restart the 6800
+
ETH after the IP address is set.
Note: If there are no arguments in the command, then it will run automatically in
interactive mode. When the front RS-232 serial port is used, only interactive mode is
supported.
Syntax
setipaddr
reboot
Definition
This command reboots the 6800
+
ETH. The Telnet session closes, and the 6800
+
ETH
restarts.
Table 4-9 getMACAddr Commands and Parameters
Command Description Parameter
getMACAddr Get MAC information None
Table 4-10 setipaddr Commands and Parameters
Command Description Parameter
setipaddr Set network parameters Variable or none