Spectrum
24
Installing the replacement module
Confirm that the new module appears in Spectrum Management after installing it.
1. Unpack the module.
2. Grasp the module handle and push firmly into the slot. Ensure the module is fully inserted by pressing
on the connectors with the palm of your hand.
3. Tighten the two lock screws on the rear panel of the module to secure it to the chassis.
4. Verify that the new module appears in Spectrum Management.
5. Connect any necessary cables to the module.
Refer to the
Spectrum Spectrum System Installation Guide
for instructions.
What to do next
Use the record of your player and channel settings for the original module to configure players, channel
properties, and GPIO settings on the replacement module. For help configuring settings, refer to the
following pages in the Help system:
• "Creating a player"
• "Configuring a channel"
• "Configuring GPIO triggers"
Activating players
Activate players from the Channels page.
• From
Configure
>
Channels
, click
Activate
for each player attached to the module.
The player status change to "Active", and the active player will be moved to the top of the player list.
