NOTEPAD
5, 8FX, 12FX
INFORMATION
INFORMATION
INFORMATION
IMPORTANT
Please read this manual carefully before using your mixer
for the first time.
This equipment complies with the Electromagnetic Compatibility directive 2014/30/EU and LVD 2014/35/EU.
This product is approved to safety standards:
IEC60065:2014 (Eighth Edition)
EN60065:2014
UL60065 2015 Ed. 8
CAN/CSA-E60065:2016 Ed. 2
And EMC standards:
EN55032: 2012+AC: 2013 Electromagnetic Compatibility of multimedia equipment - emissions requirements
EN61000-3-2:2014 Electromagnetic Compatibility - Part 3-2: Limits for harmonic current emissions
EN61000-3-3:2013 Electromagnetic Compatibility - Part 3-3: Limitation of voltage changes, voltage fluctuations and
flicker in public low voltage supply systems.
EN55103-2: 2009 (E2) Electromagnetic Compatibility - product family standard for audio, video, audio-visual and
entertainment lighting control apparatus for professional use - part2: Immunity
Warning: Any modification or changes made to this device, unless explicitly approved by Harman, will
invalidate the authorisation of this device. Operation of an unauthorised device is prohibited under Section
302 of the Communications act of 1934, as amended, and Subpart 1 of Part 2 of Chapter 47 of the Code of
Federal Regulations.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna
* Increase the separation between the equipment and the receiver
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
© Harman International Industries Ltd. 2017 All rights reserved
Parts of the design of this product may be protected by worldwide patents.
Rev 1.1
E&OE October 2017
Soundcraft is a trading division of Harman International Industries Ltd. Information in this manual is subject to change
without notice and does not represent a commitment on the part of the vendor. Soundcraft shall not be liable for any
loss or damage whatsoever arising from the use of information or any error contained in this manual. No part of this
manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic,
electrical, mechanical, optical, chemical, including photocopying and recording, for any purpose without the express
written permission of Soundcraft.
Harman International Industries Limited
http://www.soundcraft.com
