Harman Martin MAC Ultra Wash, Инструкция по безопасности и установке

Страница: 12 / 28

12
MAC Ultra Wash Safety and Installation Manual
Applying power
Warning! The MAC Ultra Wash does not have a power On/Off switch. As soon as you connect an
energized power input cable to the fixture or apply power to a power input cable that has already
been connected, the fixture will power up: check that there is no safety risk from head movement or
intense light output.
To apply power to the MAC Ultra Wash:
1. Check that the tilt lock is released and that the base is held securely. Be prepared for the fixture to light
up and the head to move suddenly when power is applied.
2. See Figure 7. line up the keys
in the power input cable’s
TRUE1 connector with the
keyways in the MAINS IN
socket (arrowed). Insert the
connector into the socket and
twist clockwise to engage. If
the connector seems difficult
to twist, remove it from the
socket, check that you have
lined up the keyways correctly
and try again – do not use excessive force. Make sure that the connector latch clicks and that the
connector is locked into the socket.
3. Apply power to the input cable to power the fixture on.
To disconnect the MAC Ultra Wash from power, pull the release latch on the connector towards you to
unlock the connector, twist the connector counter-clockwise, and then withdraw it from the MAINS IN
socket.
Figure 7: Mains input socket