Harman Infinity Kappa Perfect PowerSports, Руководство пользователя, Страница: 7 / 27

INFINITY KAPPA
6
•
Ground:
Connect the
GND
wire to the negative terminal of the vehicle’s battery, or to the
vehicle’s chassis near the battery with a screw.
NOTE:
If possible, remove any paint from the
chassis for best contact. It’s recommended to use a star washer below the ring connector for a
secure connection.
•
Remote:
Connect the remote turn-on wire to the “Remote Out” lead of the source unit, if using
low-level signal inputs with an aftermarket stereo.
NOTE:
If you’re using high-level signal inputs
(your vehicle’s speaker wires), the Kappa Perfect amplifier’s 12-volt DC offset feature will turn the
amplifier on when it senses audio signal. In this case, you will not have to connect the remote
turn-on wire and can tape or cap it off to prevent the introduction of noise.
POWER
PROTECTION
Battery
Remote turn-on (to stereo)
Fuse holder
Chassis ground
（-）
Power/Protect indicators
The power light will illuminate in green when the amplifier is getting power and playing. The light
will illuminate in red if the amp enters protect mode in the event of conditions such as over/under
voltage, short circuit, amplifier output circuit failure, or excessive heat.
Line-level Signal Input
• If your source unit offers preamp outputs, connect to the amplifier’s L and R preamp inputs using
RCA patch cables.