Introducing Your New N2300 Series Devices
7
N2312/N2322 User Manual
FIG. 3
N2322 Decoder Front Panel
FIG. 4
N2322 Decoder Rear Panel
2
4
5
1) USB Standard-A Ports
2) Device Reset Button
3) IR Emitter Input Connection
4) Device ID Discovery Button
5) Power/Status Indicators
1
3
1) 12VDC Input (not needed with PoE)
2) Status Indicators
3) RJ45 Auto-Sensing Gigabit Ethernet Switch Port — PoE
4) RJ45 Auto-Sensing Gigabit Ethernet Switch Port
5) IR Emitter Output Connection
6) RS232 Connection
7) Analog Audio Output
8) HDMI Video Output
1
2
3
8
7
6
5
4
Front and Rear Panel Descriptions
Front Panel
USB Mini-B port
For KVM support. Connects the Encoder to the computer to be controlled.
USB Standard-A port (x2)
For KVM support. Connects the Decoder to keyboard and/or mouse.
RESET button
Recessed pushbutton. Press to initiate a “warm restart” which causes the processor to reset, but not lose
power. A reset does NOT affect the current settings.
IR In port
3-pin terminal Phoenix connector. Provides infrared (IR) input only and passes signal back to the
connected Encoder/Decoder (33-60 kHz; typically 39 kHz). IR receiver required (not included).
ID button
Recessed pushbutton. Press to send notification out on the network to identify the unit (the notification
causes a pop-up dialog in N-Able and N-Command). Press and hold for 30 seconds to initiate a factory
restore.
POWER LED
On solid (green) when operating power is supplied (via PoE or local power supply). This activity is also
shown by the
PWR
LED on the rear panel.
STATUS LED
On flashing (green) when there is software activity. This activity is also shown by the
STAT
LED on the rear
panel.
Rear Panel
+12V 2A
12 Volt DC power input.
PWR LED
Same as
POWER
LED described above.
HDMI LED
On (green) when an HDMI connection exists.
STAT LED
Same as
STATUS
LED described above.
STRM LED
On (green) when the unit is streaming video.
P0 POE
8-wire RJ45 female.
10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch port.
Provides both the network connection and the power to the Encoders and Decoders.
P1
8-wire RJ45 female.
10/100/1000 Mbps 10/100/1000Base-T auto-sensing gigabit Ethernet switch port.
OR
1G SFP port which accepts compatible fiber transceivers or direct attach cables (copper or fiber).
Modules sold separately.
