QUICK START GUIDE
HPX-AV101-HDMI-R
HDMI Module with Retractable Cable
Overview
Hydraport Retractable Cable Modules are designed to be used in conjunction with the
HPX-600/900/1200 and HydraPort Touch (7”/10”) Connection Port base assembly, to
provide the convenience of various types of cables in a Hydraport System.
The
HPX-AV101-HDMI-R
HDMI Module with Retractable Cable
(FG552-27) provides a user-accessible HDMI cable in a retractable cartridge that
mounts into the Hydraport base assembly (FIG. 1).
Installation
Warning! - Do not attempt to open the retractable cable module enclosure. There are
no serviceable parts inside the module.
- Opening the module enclosure may result in an uncontrolled release of spring
forces which could cause serious injury and/or equipment damage.
- Opening the module enclosure will void the product warranty.
Warning! - The placement of the Hydraport installation in the table should ensure the
pull-out length of the cable can reach all potential users of connectivity, as
excessively pulling on a pulled-out cable can irreparably damage the retractor
module.
Caution: Only use a hand-held screw driver for the mounting instructions in this
document. Over-tightening the screws can hinder performance or damage the product.
1. For Existing HPX Installations, First Unmount the HPX Base
For new HPX installations, skip to Step 2.
For existing HPX installations, the HPX Base Assembly must be un-mounted from the
surface before the Retractable Cable Modules can be installed:
1.
Cut/remove any cable ties that would restrict the removal of the HPX Base
Assembly.
2.
Loosen the four mounting screws (located inside and at each end of the HPX base
assembly), in order to rotate the retaining tabs from under the mounting surface.
Note that when the cover of the HPX base is open, only two of these screws are
visible. To access the other two mounting screws, tip the cover over to the
opposite open position (see FIG. 2).
3.
Once the retaining tabs have been rotated out from under the mounting surface,
the HPX assembly can be be lifted away from the mounting surface.
FIG. 3 provides a cutaway view of the End Cap, showing the retaining tabs in both
the loose position and the tightened (secure) position:
2. Remove the End Cap and Existing Modules
Remove the End Cap as well as existing modules (as necessary, depending on how you
want the modules arranged) from one end of the HPX base assembly.
1.
Remove the (silver) pivot screw and pivot pawl assembly in the center of the End
2.
Remove the six (black) sheet metal screws that secure the End Cap to the HPX
assembly (locations circled in red below).
3.
Gently slide the End Cap out of the HPX base assembly.
FIG. 1
HPX-AV101-HDMI-R HDMI MODULE WITH RETRACTABLE CABLE
FIG. 2
HPX BASE ASSEMBLY (SHOWN MOUNTED) - MOUNTING SCREWS LOCATIONS
FIG. 3
HPX BASE ASSEMBLY (SHOWN MOUNTED) - MOUNTING SCREWS LOCATIONS
FIG. 4
HPX BASE ASSEMBLY (SHOWN MOUNTED) - MOUNTING/PIVOT SCREW LOCATIONS
