Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • [email protected]
DocID: 520988_19.09.2022
Quick Start Guide
This quick start guide contains important information on the safe operation of the
product. Read and follow the safety advices and instructions given. Retain the quick
start guide for future reference. If you pass the product on to others please include
this quick start guide.
Features
• Lightweight, compact pedalboard
• Battery or mains powered
• Powder-coated aluminium frame
• 11 insulated, filtered and short-circuit proof outputs eliminate noise and hum
• 4 uninsulated outputs for multi-effect devices or for charging smartphones or
tablets
• Incl. power adapter for power supply and charging
• With volt/current meter
• High current output for modern digital effects
• LED indicator on each output
EN
Spaceship Power 80-B
Scope of delivery
• 4 × DC cable with a length of 30 cm
• 5 × DC cable with a length of 60 cm
• 4 × DC cable with a length of 90 cm
• 1 × reverse polarity cable with red plug
• 1 × battery clip
• 1 × connector cable with a length of 45 cm with 5.5 × 2.5 mm green coaxial plug
to 5.5 × 2.1 mm coaxial plug
• 1 × connector cable with a length of 45 cm with 3.5 mm jack plug to
5.5 × 2.1 mm coaxial plug
• 1 × voltage boost cable, 20 cm
• 1 × current boost cable, 60 cm
• 1 × EIAJ-05 cable
• 1 × power adapter with EU plug, 120 cm
• 1 × cable fastening set
• 1 × velcro tape, self-adhesive, 400 cm × 4.5 cm
• 2 × Allen key (5 mm and 6 mm)
• 1 × transport bag with storage pocket and shoulder strap
8
O#
8
O#
8
O#
8
.+0-
8
O#
8
O#
8
O#
8
O#
8
O#
8
O#
8
O#
8
O#
8
O#
& '
(
)
*
+
ö#$%
Operating elements
Safety instructions
Intended use
This product is meant to be used as a multiple power supply for effects pedals. Any
other use or use under other operating conditions is considered to be improper and
may result in personal injury or property damage. No liability will be assumed for
damages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are
not within reach of babies and young children. Choking hazard! Ensure
that children do not detach any small parts from the product. They could
swallow the pieces and choke! Never let children unattended use electri-
cal devices.
Possible staining
The plasticiser contained in the rubber feet of this product may possibly
react with the coating of your surface and after some time cause perma-
nent dark stains. In case of doubt, do not put the rubber feet directly on
the surface and use a suitable underlay if necessary, i.e. felt-pad floor pro-
tectors or similar.
Where to use the product
Never use the product
• in conditions of extreme temperature or humidity
• in extremely dusty or dirty areas
• at locations where the unit can become wet
General handling
• To prevent damage, never use force when handling the product.
• Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use
liquid cleaners such as benzene, thinners or flammable cleaning agents.
Incorrect handling of lithium batteries can result in injury
• In the event of a short circuit, overheating or mechanical damage, lithium batteries
can cause severe injuries.
• When handled correctly and appropriately lithium batteries pose no risk.
• Store lithium batteries in a cool, dry place, ideally in the original packaging.
• Store lithium batteries away from heat sources (e.g. radiators or sunlight). Lithium
batteries are hermetically sealed. Never attempt to open a lithium battery.
• If the battery housing is damaged small amounts of the electrolyte may leak out. If
this should happen, seal the lithium battery in airtight packaging and wipe up the
traces of electrolyte using absorbent paper towels. You must wear protective rub-
ber gloves when doing so. Clean your hands and the affected surface thoroughly
with cold water.
• Never attempt to recharge non-rechargeable lithium batteries. When charging lith-
ium batteries you must use a suitable charging device intended for the purpose.
• Before disposing of the device remove the lithium batteries. Protect used lithium
batteries against potential short circuits, e.g. by covering the poles with adhesive
tape.
• Only use powder extinguishers or other suitable extinguishing agents to extinguish
a burning lithium battery.
1 USB-A output, uninsulated
2 USB-C output, uninsulated
3 Socket for the supplied power adapter for power supply and charging
4 Mains switch
5 Output 1 with 24 V @ 2000 mA, uninsulated
6 Output 2 with 9 V @ 3000 mA, uninsulated
7 Outputs 3 - 6 with each 9 V @ 250 mA, insulated
8 Outputs 7 - 9 with each 9 V @ 500 mA, insulated
9 Outputs 10 - 13 with voltage switches, insulated, switchable between
9 V @ 500 mA /
12 V @ 375 mA /
18 V @ 250 mA
10 Control LED for outputs 1 - 13, lights up green when voltage is present,
turns off when output is deactivated due to overload