4. Install one (1) plastic set
screw so it is flush with
top of car.
Install Toggle on Car
Tools
•
Small slotted screwdriver
•
Icepick
•
Phillips screwdriver
1. Remove control blocks
or swivel ears on wind-
ward assembly.
2. Remove two (2) plastic
set screws located on top
of car.
5. Insert stand-up device so
large flat end of rubber is
up. Press down and push
pivot pin into place.
6. Secure with set screw or
swivel ear screw. Assemble
control blocks using blue
Loctite
®
on screws.
Note: Use Loctite on stainless
screws only. Do not use on
plastic set screws.
1643
1 Toggle with elastomer stand-up assembled
2 Large cotter pin
HFS181
3 8 mm (5/16") clevis pin
H-80166
4 Bushing - 6 mm (1/4") (2)
H-80167
5 6 mm (1/4") clevis pin
H-80165
6 Split rings (2)
MS-002
7 5 mm (3/16") clevis pins (2)
H-35241A
8 Replacement set screws (2)
HFS971
Elastomer replacement
MP-1838
Parts List (continued)
2
1
3
4
5
6
7
8
3. Use icepick to push pivot
pin to one side. Remove
shackle.
