Remote Functions
St
ar
t
P
aus
e
Abor
t
Rst
Tot
Pr
int
A
Re
fi
ll
Re
m
ot
e
Gnd
Gnd
HI 2160RC
PLUS
MANUAL
8-20
FIG. 8-23 REMOTE SET POINT JUMPER
NOTE:
The Remote Set Points will not work without the jumper installed.
Step 3. Setting the LO Output Signal Parameter.
•
The LO setting is the minimum signal output to be refer-
enced as 0.000 lbs/min (Default Setting). Depending on
the output option board purchased the output signal range
could be 0-20 milliamps, 4-20 milliamps, 0-5 volts, 0-10
volts. The LO setting corresponds to 0 output.
•
Normally the setting is 0.000 mass units/time units but
other settings can be used to match process requirements.
When using a value other than 0.000, the value must be
below (less than) the HI value setting.
•
Press the Config button. The Main Menu appears.
•
d.Press the down arrow until the cursor is to the left of
the Remote Set Point sub-menu.
•
Press the Enter button. The Set Point Menu appears with
the cursor next to the Percentage parameter. More will be
said later about setting percentages. (See Fig. 8-24)
•
Press the down arrow until the cursor is to the left of the
LO setting sub-menu.
•
Press the Clear button to clear the old value.
NOTE:
If the old value is Zero, enter a new number. If the old value is not Zero, press the
Clear button two times, then enter the new number.
•
Use the numeric keys to enter the new value.
•
Press the Enter button to accept the new value.
•
Press the down arrow until the cursor is to the left of the
HI.
Содержание HI 2160RC PLUS
