IMPORTANT:
Before you begin, make sure you familiarize yourself with all the
parts and fully read the instructions.
TOOLS NECESSARY:
Screw gun or Phillips screwdriver. Tape measure, level and
square. NOTE: If screw gun has a clutch, set to lowest setting so
as not to over tighten and/or strip screws.
PARTS IDENTIFICATION:
A
Wood Top Assembly
1 pcs
B
Door Mounting Metal Frame
1 pcs
C
Self Adjusting Rear Bracket Set (PAIR)
1 pcs
D
#6 x 5/8” Flat Head Phillips Wood Screw
9 pcs
E
#8 x 1/2” Pan Head Phillips Wood Screw
8 pcs
F
#8 x 5/8” Flat Head Phillips Wood Screw
4 pcs
G
M4 x 10 Pan Head Phillips Machine Screw
2 pcs
H
Double Sided Tape
(Not shown)
4 pcs
Wood Top Mount
Waste Container
Scan to watch the installation video
http://delivr.com/2EPYJ
STEP 1 - Determine Mounting
Location
For a cabinet with drawer, mark from bottom of face frame
14-1/2”.
For a full height base cabinet, mark from bottom of face frame
14-1/2” minimum and 22-3/8” maximum.
STEP 2 - Install Self Adjusting Rear
Brackets, Left and Right
Using a framing square and level mark the mounting location
of the rear brackets and install each Bracket with two (2) #8 x
1/2” Pan Head Phillips Wood Screws provided.
STEP 3 - Install Slides
Separate the slides using the black separation arms shown
above. Install cabinet member of the slide at your desired
mounting location with one (1) #8 x 1/2” Pan Head Phillips
Wood Screws provided.
STEP 4 - Prepare Wood Top Assembly for Install
Placing the Wood Top Assembly on a flat surface, place the Door Mounting Metal Frame on the Wood Top as shown above and align
with the pre-drilled holes. Secure in each location shown with #6 x 5/8” Flat Head Phillips Wood Screws provided. Then install the two
(2) M4 x 10 Pan Head Phillips Machine Screws into the front of the slides brackets as shown.
#6 x 5/8” Flat Head
Phillips Wood Screws
#6 x 5/8” Flat Head
Phillips Wood Screws
M4 x 10 Pan Head Phillips
Machine Screws
Installation Instructions for
the CAN-TMDSC-15
G
B
A
C
E
F
D
