Strona
3
z
16
1.
GENERAL INFORMATION
1.1 Producer
HARDO CZAPSKI I WSPÓLNICY SP. J.
Ul. Spacerowa 5
32-83 Balice, Poland
1.2 Information on this manual
NOTE:
BEFORE USING THE DEVICE, READ THESE INSTRUCTIONS.
This manual describes the rules for safe and correct handling of devices. The safety recommendations contained in the
manual, accident prevention measures as well as general safety measures must be followed. The instructions should
be accessible to operating and maintenance personnel and kept throughout the useful life of the product.
1.3 Compliance with standards and regulations
OptiLine series lighting fixtures have been designed and manufactured in accordance with the requirements of:
a) Directive on the harmonization of the laws of the Member States relating to equipment and protective systems
intended for use in potentially explosive atmospheres
ATEX 2014/34/EU.
b) Directive on electrical equipment designed for use within certain voltage limits
LVD 2014/35/EU
c) Directive on the harmonisation of the laws of the Member States relating to electromagnetic compatibility
EMC
2014/30/EU.
A detailed summary of standards is included in the EU declaration of conformity.
2.
DEVICE DESCRIPTION
OptiLine luminaires are luminaires equipped with high-efficiency LED light sources. Depending on the version, they can
be used as basic and/or emergency lighting. The product meets the essential safety requirements contained in the
ATEX Directive for category II devices of categories 3G, 2D and 3D, as well as the requirements of the IECEx system.
Detailed guidance on potentially explosive atmospheres is given in this document.
Luminaires are approved for use in both external and internal installations. The external housing of OptiLine luminaires
is made of glass fibre reinforced polyester (GRP) bottom body and made of polycarbonate (PC) diffuser which is also
the lampshade of the luminaire. The luminaire shade is available in three versions: transparent, opal and frosted. It is
possible to use LED drivers with the DALI system in luminaires.
The connection of both these elements is sealed with a gasket made of silicone foam.
External electrical cables have to be introduced into the housing using certified cable glands. Depending on the
components used, they have a degree of protection against the ingress of solids and liquids at the level of IP 66/67. The
housing of the luminaires is resistant to moisture and UV radiation, which allows it to work in outdoor conditions. The
housing materials used provide high resistance to mechanical impact. The luminaire is made as a single-chamber
device. The housing is closed/opened by means of stainless steel closing clips that prevent the housing from being
opened without a tool. Inside the housing, there is a bottom frame made of powder-coated steel. Depending on the
configuration of the luminaire, the lower frame is a place of installation for: LED driver, cable connectors, through wiring,
Ni-Cd battery pack, CBX and CBY switching modules. The bottom frame is attached to the GRP bottom body with plastic
mounting screws. The HEX5416 1/2/3 LED light modules are mounted to the powder-coated steel top frame. Both
frames are connected to each other by means of a set of rivet nuts and bolts.