HARDKERNEL ODROID-XU4, Руководство пользователя

Страница: 9 / 92

4
ODROID-XU4 USER MANUAL
Power Supply
The XU4 board requires a 5V/4A DC power source. The dedicat-
ed power connector (miniature barrel jack) can accept a DC plug cable
with a plug that has an outer diameter of 5.5mm and an inner diameter
of 2.1mm. The plug inner core (center) is positive (attached to the RED
wire in the cable) and outer cylinder is negative (attached to BLACK
wire in the cable). The XU4 can be powered using different options,
which are outlined below.
5V DC 4A Power Supply
Attach the plug to the power connector on the XU4. Plug the
2-pin PSU into the power outlet. The pins are Asian standard, and you
may need an adapter to use in your region, such as the Americas. The
PSU pictured above is available from Hardkernel.
DC plug cable
If you have a 5V DC 4A PSU which does not have the required
plug, you can cut off the plug from such a power supply. Expose about
½” of the red/black wires on the psu cable and attach them to the same
colored cables of this cable, then solder the joints. You can cover the
joint using electrical tape or a heat-shrink wrap. Attach the plug to the
XU4 and insert the PSU pins into a power outlet.
Chapter 1