Hardi ZENIT 400, Оригинальная инструкция

Страница: 87 / 118

83
6 - Maintenance
Transmission shaft
The universal joints and bearings should be lubricated with grease. At
points marked (A), this should be done after every 10 working hours,
and the tubes and axles (B) every 50 hours.
Remember to lubricate the joints of the transmission shaft between
pump and fan gearbox as well.
Mechanical clutch
The clutch will transfer power via the pump to the gearbox. It consist
of two sprockets (A) and a double chain (B) which holds them together.
The chain must be greased every 50 hours to avoid unnecessary wear
and tear.
When the chain is worn, it is recommended to change all parts, as a
new chain on worn sprockets will wear faster.
Diaphragm pump
Grease the pump every 50 working hours or once a month, through
the grease nipple located at the crankshaft axle. The grease travel
along the grooves in the crankshaft to reach the crankcase where it is
distributed around bearings, conrods, etc.
Greasing is carried out in the same way on both pump models 363 and
463.
ATTENTION! Insufficient greasing of the pump could cause it to
overheat and break the mobile parts inside.
Pump models 363 and 464 have external central grease nipples.
A A
A A
A A
B
B
35
g
A A
A
A
B