Hardi ZENIT 400, Оригинальная инструкция

Страница: 41 / 118

37
4 - Starting up
Hooking up the mistblower
If your mistblower has a semi-automatic quick hitch, follow the steps
set out below:
1. Place the quick hitch boom in the hydraulic lift arms of the
tractor.
2. Fit the linch pins to secure the boom to the hydraulic lift arms.
3. Completely lower the boom with the tractor’s hydraulic lever.
4. Reverse the tractor until it touches the chassis, placing this as
near the middle as possible.
5. Attach the top link to tractor and sprayerand adjust it by hand.
6. Raise the tractor’s lower links with the hydraulic lever until the
boom fits perfectly into place.
7. When the boom is correctly attached, the two hooks will close
automatically and the equipment will be fixed to the tractor.
8. Put the safety pins of the semi-automatic quick hitch on
to avoid the equipment from becoming detached during
transportation or spraying.
9. Place the equipment at the height needed.
10. Ajdust the top link until the equipment is completely
perpendicular to the ground.
To detach the mistblower you should proceed in the following way:
1. Lower the tractor’s hydraulic arms with the hydraulic lever until
the equipment is touching the ground.
2. Pull the cable release the boom from the semi-automatic quick
hitch.
3. Loosen the top link
4. Pull out the retaining pin from the top link to completely detach
the mistblower.
5. Drive the tractor away slowly.
WARNING! The tractor’s hydraulic lower links should be moved
very gently to prevent damages or tipping over.