Hardi Mercury Covamax series, Инструкция оператора

Страница: 86 / 110

6 - Maintenance
1. 16
Maintenance Schedule
Review the following maintenance schedule regularly to determine when maintenance is required. This
maintenance schedule is a guide only and can be increased in frequency if desired.
Consult the maintenance section of this manual for proper maintenance procedures.
Service to be Performed Interval
X - REQUIRED SERVICE INTERVAL
10 HRS 50 HRS 250 HRS 1 Y
E
AR
As
R
e
qui
red
Check wheel nut security X
Check tyre inflation X
Check gearbox oil level X
Check product pump oil - AR Pumps X
Lubricate drive shaft lock pins X
Lubricate drawbar grease nipples X
Check hydraulic oil level (Tractor) X
Check hydraulic lines and fittings for leaks X
Inspect fluid system for leaks X
Clean suction filter X
Clean pressure filters X
Lubricate drive shaft joints X X
Lubricate boom grease nipples X X
Lubricate boom pivots X X
Retorque wheel nuts to 330Nm (243 ft.lb) X
Lubricate wheel bearing caps X
Lubricate product pump input shaft grease nipple - HARDI 363 X
Adjust boom X
Check and Clean spray nozzle filters X
Check bearing play in wheel hubs X
Change gearbox oil X
Change product pump oil - AR Pumps X
Retorque wheel nuts to 330Nm (243 ft.lb) X
Check hydraulic lines and fittings for leaks X
Inspect fluid system for leaks X
Clean and re-lubricate boom grease nipples X
Clean and re-lubricate boom pivots X
Clean and repack wheel bearing assemblies X
Check blower fan bearing end play X
Clean and re-lubricate drive shaft joints X
Clean and re-lubricate drawbar grease nipples X
Change gearbox oil X
Change product pump oil - AR Pumps X
Lubricate product pump input shaft grease nipple - HARDI 363 X
Replace pump valves and diaphragms X
Check and Adjust EVC pressure regulator X
Check cone for section distribution valves X
Replace drain valve seal X