Hardi MASTER PRO VHH, Инструкция, Страница: 25 / 82

25
4 - Sprayer setup
General info
Before putting the sprayer into operation
Although the sprayer has been supplied with a strong and protective surface treatment on steel parts, bolts etc. in the
factory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILO or SHELL ENSIS FLUID) on all metal parts
in order to avoid chemicals and fertilizers discoloring the enamel.
If this is done before the sprayer is put into operation for the first time, it will always be easy to clean the sprayer and keep
the enamel clean for many years. This treatment should be carried out every time the protection film is washed off.
Unloading the sprayer from the truck
For the unloading of the sprayer, you need a crane. When unloading
with a crane please observe the lifting points as shown in the picture,
and make sure that the straps or belts used for lifting are strong enough.
μ
ATTENTION! Only lift the sprayer when the tanks are empty!
Counter balance
μ
ATTENTION! Note the weight of the sprayer. General
recommendations are as follows:
1.
Add ballast to the front of the tractor, if necessary.
2.
Check tyre pressure (see tractor’s instruction book).
3.
Be careful when filling/lifting the sprayer for the first time.
4.
Ensure that the operating unit and the tractor do not touch.
5.
Travel at slower speeds when driving with a full tank, as the tractor braking effect will be reduced.