Page 3
For technical questions, please call 1-888-866-5797.
Item 61405
ASSEMBLY INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
document including all text under subheadings therein before set up or use of this product.
The Hydraulic Lift Table requires some
assembly after you unpack it.
1.
Front
Wheels
(47)
Lock Nuts (14)
Washer (15)
Bushing (48)
Hex Bolts (16)
Figure 1
First, set aside the hardware needed to
install the Front Wheels (47). The hardware
includes the Hex Bolts (16), Lock Nuts (14),
Washers (15), and Bushings (48).
Front Wheel
(47)
Wheel
Frame
Washer (15)
Wrench
Lock Nut (14)
Figure 2
2. Turn Lift Table on its side. Slide Bushing through
center hole in the Front Wheel. Then set Front Wheel
in the wheel frame of the Base Assembly (17).
Slide the Hex Bolt through the Washer, wheel
frame and Bushing. Use a wrench (sold separately)
to fasten Lock Nut onto Hex Bolts, until the
Front Wheel is secured into place.
3.
Lifting Pedal
Connector
(30a)
Lifting
Pedal
(27)
Bolt (29)
Wrench
Figure 3
Slide Lifting Pedal (27) into Pedal
Connector (30a), aligning the installation holes.
Then slide the Bolt (29) through the Washer (15)
and through the installation holes. Use the
wrench to fasten the Lock Nut (12) over the Bolt,
securing Lifting Pedal in place. See Figure 3.
4.
Handle
(21)
Bolt (20)
Base
Assembly
(17)
Wrench
Figure 4
Slide the ends of the Handle (21) into the
handle slots on the Base Assembly (17).
Use the wrench to tighten the Bolts (20) until Handle
is securely fastened in place. See Figure 4.
5.
WARNING! TO PREVENT SERIOUS INJURY:
After assembly, try out the Lift Table to make sure it
is functioning properly before using it to lift a load.