10
1.
1
Replace vice (Q) and adjust length of safety cable
(R), preassembled to motor housing (D), by
loosening screw and nut on the vice (Q) and pulling
on the safety cable (R). Adjust slack in safety cable
(R) to a hand’s length and re-tighten screw and nut
on vice (Q) securely. The loop at the end of the
safety cable (R) should just fit over the threads on
the wood screw (not included).
Test safety cable (R) by pulling on loose end with
pliers. If the safety cable (R) slips, then screw and
nut on vice (Q) must be set tighter.
Q
Screw
Nut
Loop
Wood
Screw
INSTALLING SAFETY CABLE
2. Find a secure attachment point (wood ceiling joist
recommended) and secure safety cable (R) using
a heavy-duty wood screw, washer and lock
washer (none included).
NOTE:
Extra cable slack can be left in ceiling
area.
R
Wood Screw,
Washer and
Lock Washer
Wood
Joist
2
Loop
R
14. Install hanging ball of downrod (A) into opening of
mounting bracket (C). Align one of the slots in
hanging ball with the tab in mounting bracket (C).
DANGER:
Failure to align slot in hanging ball
with the tab in mounting bracket (C) may result in
serious injury or death.
CAUTION:
Assistance from another person is
recommended for this step.
C
Tab
14
A
Slot
INITIAL INSTALLATION
