FAN MOUNTNG
10
Lowes.com/harborbreeze
Install ball end of downrod (A) into opening of
mounting bracket (C). Align slot in ball with tab in
mounting bracket (C).
DANGER
: Failure to align slot in ball with tab
may result in serious injury or death.
9.
Slot
Tab
C
A
9
Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring. If you decide to cut back the lead wires, it is
suggested you do so in the following manner:
Take the lead wires and make sure you have pulled
them all the way through the top of the downrod.
Start at the TOP of the ball on the downrod and
measure 8 in. of lead wire, and then cut the excess
wire off with wire cutters (not included).
NOTE:
If you do
not
cut back the lead wires,
Steps
7 and 8 are not necessary and you may proceed
to Step 9 instead
.
Ball
7.
7
O
If you decided to cut back the lead wires in Step 7,
strip 1/2 in. of insulation from end of white wire.
Twist stripped ends of each strand of wire within
the insulation with pliers (not included). Repeat
Step 8 for black, blue (if applicable) and green
wires.
8.
8
