9
8
DOWNROD STYLE FAN MOUNTING
3. Loosen the two set screws from the yoke on
the top of the motor housing (G). Slip downrod
assembly (D) into housing yoke, aligning holes
in downrod assembly (D) and yoke. Insert the
pin through yoke and downrod assembly (D).
Insert clip into pin until it snaps into place.
Tighten set screws.
4. Install hanger ball on the top of downrod (D)
into mounting bracket (A) opening. Rotate fan
until slot on hanger ball engages the tab on
the mounting bracket (A).
1. Remove the canopy cover (C) from the
bottom of the canopy (B).
D
G
clip
pin
set
screw
3
A
D
slot
tab
4
B
C
1
WARNING:
Be careful when aligning the tab
to the slot! If not fully engaged, there is a
possibility of fan falling, which may result in
serious injury or death.
CLOSEMOUNT STYLE FAN MOUNTING
CLOSEMOUNT STYLE FAN MOUNTING
2. Remove three of the six screws and
lockwashers (every other one) securing
the motor collar to the top of the fan motor
housing (G).
3. Place the rubber gasket (EE) over the
remaining screws. Pull wires through hole in
canopy (B), and attach canopy (B) to motor
housing (G). Align the mounting holes with
the holes in the motor and fasten using the
three screws removed in previous step.
Tighten the screws securely.
4. Hang the fan on the hook on the mounting
bracket (A) using one of the non-slotted
holes in the canopy (B).
G
2
G
EE
B
3
B
A
hook
4
You may now proceed to the WIRING section
on page 10.
Hardware Used
Rubber gasket
x 1
EE
