Hanwha Vision XWV-3010, Быстрое руководство

Страница: 10 / 18

10_ Execution
Execution
Power Supply
Plug all of the power cords into the back of the product, and press the power button.
If the product does not turn on, check the following.
1. Make sure that all the power cords have been plugged in firmly, and that they meet the required power
specifications.
2. If you are using a power strip, make sure that the power strip is turned on.
J
`
If all the power cords are plugged in firmly but the power does not turn on even after you have pressed the power
button, follow the procedure described below.
This product can be operated in power protection mode to protect it in the event of a power outage or instability
in the power supply.
This is similar to the operation of the fuse of the earth leakage circuit breaker. It is not a malfunction of the product.
Follow the steps described below.
1) Unplug all of the power cords from the back of the product.
- If you are using a power strip, turn off the power strip.
2) Wait 10 seconds after the cords have been removed.
- The protection circuit is now initialized, as the current inside the power supply has been discharged.
3) Plug in the power cords again.
- If you are using a power strip, turn it on again.
4) Press the power button on the product.