Hanwha Vision QND-7022R, Руководство пользователя

Страница: 16 / 40

16_
installation & connection
installation & connection
INSTALLATION (QND-7012R/7022R/7032R/7082R)
Precautions before installation
Ensure you read out the following instructions before installing the camera:
~
It must be installed on the area (ceiling or wall) that can withstand 5 times the weight of the camera
including the installation bracket.
~ Stuck-in or peeled-off cables can cause damage to the product or a fire.
~
For safety purposes, keep anyone else away from the installation site.
And put aside personal belongings from the site, just in case.
~ If the product is installed with excessive force, it may cause damage to the camera due to malfunction.
Forcing assembly using non-compliant tools may damage the product.
Disassembling
1. Use one hand to hold the camera’s bottom part and turn the cover
counterclockwise with another hand to separate it.
J
`
Do not touch the transparent part of the dome cover once the protective
film is removed.
2. Lift up the inner cover to separate it.
Installation
1. Consider the direction to be monitored, attach the template, and
drill holes by following the template.
2. Using 2 tapping screws, fix the camera at 2 holes drilled with a
template.
`
Set the < > mark imprinted on the camera to face the direction of camera
monitoring.
3. Connect the camera internal terminal with the corresponding
cable.
4. Adjust the lens in a desired direction by referring to the “ Adjusting
the monitoring direction for the camera
” section. (page 23)
J
`
We recommend you not to touch the lens as the camera lens has been
properly focused in the final process of manufacturing. If so, the lens may be
out of focus or stained by alien substances.
5. Please connect the inner cover to the main body.
6. While grabbing the bottom side of the camera with your hand, please
grab and push its cover with the other hand to align the two arrow signs,
as shown in the figure.
J
`
To assemble the dome cover, make the arrows match each other and press the
cover firmly.
If the dome cover is rotated during assembly or is assembled incorrectly, diffused
reflection may occur or the lens section may rotate, which will cause the shooting
range to be changed.
`
Make sure that the dome cover is correctly connected to the bottom part as shown
in the figure.
If the snap-fit is not connected correctly, the dome cover may fall, which may cause
injury.
NETWORK
ACT LINK
FRONT
3. 4. GND
2. ALM OUT
1. ALM IN
5. AUDIO IN
DC12V
Dome Cover
NETWORK
ACT LINK
FRONT
RESET
3. 4. GN
D
2. AL
M
OUT
1. ALM IN
5. AUDIO IN
NETWORK
ACT LINK
FRONT
RESET
3. 4. GND
2. ALM OUT
1. AL
M
IN
5. AUDIO IN
DC12V
NETWORK
ACT LINK
FRONT
RESET
3. 4. GND
2. ALM OUT
1. ALM IN
DC12V
NETWORK
ACT LINK
FRONT
RESET
2. ALM OUT
1. ALM IN
DC12V
4 5 GND
VIDEO
NETWORK
ACT LINK
FRONT
RESET
3. 4. GND
2. ALM OUT
1. ALM IN
DC12V
FRONT
RESET
2. ALM OUT 1. ALM IN
DC12V
4 5 GND
VIDEO