Hanwha Vision ANE-L7012L, Руководство пользователя

Страница: 14 / 25

installation & connection
14_
installation & connection
INSERTING/REMOVING A MICRO SD MEMORY CARD
J
`
Before installing the camera, the Micro SD card should be inserted while the power source and the body are separated.
` Do not forcefully insert it in the reverse direction. It might damage your Micro SD card and your product.
` When it rains or the humidity is high, insertion or ejection of a Micro SD card is not recommended.
` Disassembly of the product cover should be finished within 5 minutes, or there will be the risk of internal dew condensation.
Inserting a Micro SD Memory Card
1. Remove the middle cover and unfasten screws on the inside cover bracket.
2. Rotate it 90° so that the SD cover faces the front, as shown in the
picture.
3. Completely tilt the camera towards the back.
4. Use the L wrench provided as a tool to release the SD cover.
5. Slide in the Micro SD card following the direction shown in the picture.
Removing a Micro SD Memory Card
Gently press down on the exposed end of the memory card as shown in the diagram to eject the memory
card from the slot.
J
`
Before removing the Micro SD card, in < Setup ( ) >-< Event >-< Storage >, set the device to < Off > and press the [ Apply ]
button and turn the camera off.
` If you turn off the camera or remove the Micro SD memory card that contains data from the product, the data may be lost or
damaged.