Application measurement
EN
Copyright © Qingdao Hantek Electronic Co., LTD
HBT3000 series user manual
39
6.6.1
LAN
Click on
[Utility] ->
IO
->
LAN
in sequence to enter the LAN settings menu.
LAN parameter settings include: IP mode, IP address, subnet mask, and gateway.
Figure 6-19 LAN parameter settings
Switch input boxes by left/right clicking, click
[OK]
to select the input box, click
up/down to modify the value, click left/right to move the cursor position, and
click
[OK]
again to exit the current input box. After setting the LAN parameters,
use the arrow keys to position the cursor to confirm, click
[OK]
to save and exit.
Note:
In the LAN parameter setting interface, if no operation is performed for
more than 30 seconds, the instrument will automatically close the LAN parameter
setting interface.
6.6.2
Serial
Click on
[Utility] ->
IO
->
Serial
Port to enter the Serial Port Settings menu.
The serial port parameter settings include Baud, Data, Check, and Stop.
Set the baud rate, click on the corresponding soft key to select the appropriate
baud rate.
Set the data bit and click the corresponding soft key to select the appropriate
data bit.
Set the checksum, which can be selected from no checksum, odd checksum, and
even checksum.
Set the stop position and click the corresponding soft key to select the desired
stop position.
