Application measurement
EN
Copyright © Qingdao Hantek Electronic Co., LTD
HBT3000 series user manual
29
Figure 6-7 Set comparator function
After entering the comparator interface, there are two methods to modify the
corresponding settings:
Method 1: Use the up/down keys of the arrow keys to move the white box to the
corresponding setting. After confirming the setting to be modified, click the
left/right keys of the arrow keys to modify the corresponding parameters.
Method 2: Click on the menu soft key to set it.
1.
Switch
Press the soft key to select whether to turn the comparator function on or off.
2.
Comp Mode
Press the soft key to select automatic or manual mode.
3.
Buzzer
Press this soft key to set the buzzer to sound. The available types are closed,
HL, IN, BT1, and BT2.
Off: The buzzer is in the off state.
HL: When the comparison result is Hi or Lo, the buzzer emits a "beep..."
sound.
In: When the comparison between voltage and resistance is In, the buzzer
emits a continuous beep sound.
BT1: When the comparison result is In, the buzzer emits a "beep" sound
(continuous sound), and when Hi and Lo, the buzzer emits a "beep..." sound.
BT2: When the state changes from Hi and Lo to In, the buzzer only emits a
"beep" (short sound) once, and when Hi and Lo, the buzzer emits a "beep..."
sound.
4.
Res
Press this soft key to set the Limits and Percent of the resistance.
Select the Limits, set the Max(m
Ω
) and Min(m
Ω
).
Select the Percent, set the Datum(m
Ω
) and Percent (%).
5.
Vol
