Hansa C65RX O&M Manual
–
OM-029 First Release 4/05/2021
© Hansa Chippers 2021
20
•
With the machine off and cutting rotor stopped, the feed roller area can be accessed safely.
Do NOT
attempt to access this area unless the engine is off, and rotor has stopped turning.
Opening the rotor cover for access to cutting rotor
WARNING!
Do NOT
open rotor cover
when engine is on and/or rotor is still
spinning.
Ensure rotor has stopped spinning. Remove
the two bolts from rotor cover and
disconnect the rubber bonnet latch.
Ensure outlet chute rotation is locked. Pull on
outlet chute to swing rotor cover open.
Reverse process to close. Do not operate the
machine without the rotor cover bolts
installed.
1
2
Pull outlet chute here to
swing rotor cover open
Note: C65RX model shown in this image
Swing arm up
Rotor pin
