Hans Grohe Crometta S 240 1jet Showerpipe Reno 27342007 Скачать руководство пользователя страница 4

Страница: 4 / 17

Assembly see page 4

Fault

Cause

Remedy

Insufficient water

Supply pressure inadequate

Check water pressure (If a pump has been installed
check to see if the pump is working).

Filters are dirty

Clean filter in front of the mixer and on the MTC-
thermo cartridge

Shower filter seal dirty

Clean filter seal between shower and hose

Instantaneous heater didn't work with thermostat

Filters are dirty

Clean the filter / exchange filter

check valve hasn't moved back

Exchange check valves

Spare parts

(see page 12)

Flow diagram

(see page 6)



Hand shower



overhead shower

Dimensions

(see page 6)

Cleaning

(see page 8 and enclosed brochure)

Maintenance

(see page 11)

• The check valves must be checked regularly according to DIN EN

1717 in accordance with national or regional regulations (at least
once a year).

Operation

(see page 11)

To empty the overhead shower after use, hold it in a slightly inclined
position.

Do not use silicone containing acetic acid!

Symbol description

Safety Notes

Gloves should be worn during installation to prevent crushing and cutting
injuries.

The arm of the shower head is intended only to hold the shower head. Do not
load it down with other objects!

Children as well as adults with physical, mental and/or sensoric impairments
must not use this product without proper supervision. Persons under the influ-
ence of alcohol or drugs are prohibited from using this product.

Do not allow the streams of the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between the shower and you.

The product may not be used as a holding handle. A separate handle must be
installed.

The shower system may only be used for bathing, hygienic and body cleaning
purposes.

Installation Instructions

• Prior to installation, inspect the product for transport damages. After it has been

installed, no transport or surface damage will be honoured.

• The pipes and the fixture must be installed, flushed and tested as per the applica-

ble standards.

• The plumbing codes applicable in the respective countries must be oberserved.
• The installation dimensions stated in these installation instructions are ideal for

people of approximately 1700 mm in body height. The dimensions can be
altered if required. In this case, pay attention to the fact that a change of instal-
lation height will also change the minimum height, and that the altered mounting
dimensions must be taken into consideration.

• Where the contractor mounts the product, he should ensure that the entire area of

the wall to which the mounting plate is to be fitted, is flat (no projecting joints or
tiles sticking out), that the structure of the wall is suitable for the installation of the
product and has no weak points. The enclosed screws and dowels are only suit-
able for concrete. For another wall constructions the manufacturer's indications of
the dowel manufacturer have to be taken into account.

• The shower may only be connected downstream of a shut-off valve or sanitary

fitting.

• The premounted filter insert must be used to ensure a normal flow of the shower

and to prevent dirt from entering through the pipes. Dirt entering can affect the
function and/or lead to damages to the shower. Hansgrohe will not be held
liable for this type of damage.

• If required, the bottom part of the pipe between the fixture and the shower head

can be shortened with a fine-toothed saw.

• The shower arm of the head shower can only be adjusted to the desired angle

once during installation. Subsequent adjustment during showering is not possible.

English

Technical Data

Operating pressure:

max. 1 MPa

Recommended operating pressure:

0,25 - 0,5 MPa

(1 MPa = 10 bar = 147 PSI)
Hot water temperature:

60°C