0 4
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective coun-
tries must be observed.
T E C H N I C A L D A T A
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 70°C
Recommended hot water temp.:
65°C
Thermal disinfection:
max. 70°C ⁄ 4 min
The product is exclusively designed for drinking water!
O P E R A T I O N (see page 35)
A S S E M B L Y (see page 32)
F A U L T
C A U S E
R E M E D Y
⁄ Mixer stiff
⁄ Cartridge defective, calcified
⁄ Exchange cartridge
⁄ Mixer dripping
⁄ Cartridge defective
⁄ Exchange cartridge
⁄ Hot water temperature too low, no
cold water. Instantaneous water
heater starts up when cold water is
selected.
⁄ Hot water limiter incorrectly set
⁄ Set hot water limiter
⁄ Crossflow
⁄ Exchange cartridge
⁄ Diverter not operating
⁄ Residue
⁄ Clean converter ⁄ grease O-rings
⁄ Water pressure to low
⁄ Increase water pressure
⁄ Diverter defective
⁄ Exchange diverter
D I M E N S I O N S (see page 31)
A D J U S T M E N T (see page 34)
To adjust the hot water limiter. Using a hot water
limiter in combination with a continuous flow
water heater is not recommended.
C L E A N I N G
see enclosed brochure
S P A R E P A R T S
(see page 36)
XXX = Colors
000 = chrome plated
340 = Brushed Black Chrome
800 = stainless steel optic
Do not use silicone containing acetic acid!
S Y M B O L D E S C R I P T I O N
F L O W D I A G R A M
(see page 31)
Rate of flow by 0,3 MPa:
Shower outlet
Tub outlet
EN
T E S T C E R T I F I C A T E (see page 38)
Содержание AXOR Uno2 Series
Страница 32: ...3 2 X 1 2 mm X 11 1 2 1 2 3 5 4 SW 4 mm 5 Nm 2 3 1 2 01800180 ...
Страница 39: ...3 9 ...